Changing the IRQ for the Scanner card without a mouse

To get the Start Menu

Ctrl + Esc, + Pause (Continue to Choosing Device Manager)

Arrow up to Settings. . .
Arrow right to Control Panel. . .
Hit Enter

Choosing System from the Control Panel


Arrow down to System. . . or
Hit 'S' on until System is highlighted. . .
Hit Enter.

Choosing Device Manager


When the General Tab is highlighted, arrow right one time.

Entering Device Manager


Tab twice until Computer is highlighted. . .
Arrow down to SCSI controllers.

Changing a plus to a minus


If the SCSI controllers line has a plus next to it, hit the '+' key to expand this selection,


otherwise. . . arrow down to Symbios Logic line.

Choosing Symbios Logic properties

DO NOT HIT ENTER (This will close the System Properties)
Tab once to Properties. . .
and hit Enter

Selecting the Resources Tab


Tab three times -or- Shift + Tab once to highlight General tab.
Arrow right three times. . .

Changing the Resources for the SCSI Card


Tab once to Input/Output Range. . .
Arrow down once to Interrupt Request. . .
Tab once until Use Automatic Settings is highlighted. . .
Hit space bar to uncheck checkbox. . . Change Setting... button should become active. . .
Shift + Tab one time to highlight Change Setting... button. . .
Hit Enter

Changing the Resources for the SCSI Card


Arrow up or down to change the IRQ. . .
After making the IRQ change, tab twice to the OK button. . .
Hit Enter.
Tab until the OK button is highlighted. . .
Hit Enter